When PCMCIA sleeve meets KR-060122(PGF battery). 

Install PGF to the PCMCIA sleeve is an alternative best method for promoting the power, need no soldering, what your need to do is replace the original battery on the PCMCIA to PGF, then simply you get power of twice or more.

What is the actual effect to install PGF on PCMCIA? Is it hard to install, the following test report and steps for installation will unfold your doubt.

Test result

 Test 1

 Test equipment: H3630 (OS: PPC2K2 Ver.: English 64MB RAM 32MB ROM) + original PCMCIA sleeve (Brand new purchased and only gone through two discharge cycles.)

 Test method: Slow charge for 1 hour after full charged and then start test, continue start the unit at super bright without operation, only PDA Time for ARM installed, the screen stay at "SETTINGàPOWER" .

 Test cycle: 3 times

 Test result: test until auto shut off, average time is 4 hours and 28 minutes

Test 2

 Test equipment: H3630 (OS: PPC2K2 Ver.: English 64MB RAM 32MB ROM) +  PCMCIA sleeve install PGF

 Test method: Slow charge for 1 hour after full charged and then start test, continue start the unit at super bright without operation, only PDA Time for ARM installed, the screen stay at "SETTINGàPOWER" .

 Test cycle: 3 times

 Test result: test until auto shut off, average time is 8 hours and 10 minutes

Test 3

 Test equipment: H3630 +PGF+HyperDrive(OS: PPC2K2 Ver.: English 64MB RAM 32MB ROM) + PCMCIA sleeve install PGF

 Test method: Slow charge for 1 hour after full charged and then start test, continue start the unit at super bright without operation, only PDA Time for ARM installed, the screen stay at "SETTINGàPOWER" .

 Test cycle: 3 times

 Test result: test until auto shut off, average time is 11 hours and 10 minutes

Step of installation:

1. Use T6 screwdriver to remove the casing (twist the back jacket gently after removal of screw to detach). 2. Press the eject tap of the PCMCIA and remove the back cover.
3.Replace original battery to PGF. 4.Remove the main board and connect the battery connector and assemble.
5.Properly screw the screws to it's original position. 6.Replace the cover of the PCMCIA sleeve properly and tighten screws.

There's no dimension problem when installing PGF to your PCMCIA sleeve.

Photo by H.S.Y.

Report by KingRex Technology    Edition 1.0   Apr/12/'02